|
|
| Domestic Reverse Osmosis System TECHNICAL SUPPORT INFORMATION |
| Primary Assembly Components | |||
|---|---|---|---|
| Prefilter (Filter 1): 5 micron sediment filter |
Prefilter (Filter 2): Sediment/activated carbon block filter |
Membrane: Thin Film Composite (T.F.C.) |
Post Filter: In0line activated carbon filter |
| R.O. Membrane Information | |
|---|---|
| Type: | T.F.C.-24 |
| Rated Membrane Production1: | produces 24 +/- 4 gpd (76-106 lpd) |
| Rated Membrane TDS Reduction1: | 95% minimum |
1Measured at Industry Standard condition of 65 psig, 77°F (25°C), 500 mg/L TDS and discharging to atmosphere. NOTE: Actual system production and contaminant reduction will depend on water temperature and pressure, TDS level, membrane variation and usage pattern. |
|
Conditions of Use
| |
| Water Supply: | Potable chlorinated or non-chlorinated |
| Water Pressure: | 40-100 psig |
| Water Temperature: | 40-100°F (4-38°C) |
Water Supply Parameters
| |
| Hardness: | less than 170 mg/L or softened |
| Iron: | less than 0.1 mg/L |
| Manganese: | less than 0.05 mg/L |
| Hydrogen Sulphide: | None |
| pH Range: | 6-9 |
| TDS Level: | no more than 1500 mg/L |
| Chlorine: | see note below |
| Bacteria: | water source must be potable |
Chlorine will damage a TFC membrane. The Carbon Block Pre-filter will remove chlorine from the incoming water. Carbon Filter to be changed every six months, more often if water contains more than 1ppm chlorine. Do not use with water that is microbiologically unsafe or of unknown quality; without adequate disinfection before or after the system. |
|